Get Support
123-456-789-10
DANOPREN 500 60
DANOPREN 500 60 is a rigid extruded polystyrene (XPS) foam board with shiplap edges at various thicknesses. Manufactured without CFC's, HCFC's or HFC's. _
Designation Code for CE Marking: _
XPS-EN13164-T1-CS(10\Y)500-WL(T)0,7-DS(70)
INTENDED USE
Thermal Insulation for Buildings (ThIB)
High load-bearing floors (cold stores, parking decks, etc).
| PRESENTATION | VALUE | UNIT |
|---|---|---|
| Length | 125 | cm |
| Width | 60 | cm |
| Total thickness | 60 | mm |
| m2 per package | 5.25 | m2 |
| Product Code | 480103 | - |
| TECHNICAL DATA | VALUE | UNIT | STANDARD |
| Thickness | 60 | mm | EN 823 |
| Thickness tolerance | -2/+3 | mm | EN 823 |
| Length | 125 | cm | EN 822 |
| Length tolerance | -8/+8 | mm | EN 822 |
| Width | 60 | cm | EN 822 |
| Width Tolerance | -8/+8 | mm | EN 822 |
| Flatness | 6 | mm/m | EN 825 |
| Squareness | 5 | mm/m | EN 824 |
| Thermal conductivity (1) | 0,034 | W/mK | EN 12667 |
| Thermal Resistance | 1,80 | m2K/W | EN 12667 |
| Compression strength (2) | ≥ 500 | kPa | EN 826 |
| Compressive creep max 2% deflection after 50 years(3) | ≥ 150 | kPa | EN 1606 |
| Long-term water absorption by total immersion | ≤ 0.7 | Vol.% | EN 12087 |
| Long-term water absorption by diffusion | ≤ 3 | Vol.% | EN 12088 |
| Water absorption by freeze-thaw cycling | ≤ 1 | Vol.% | EN 12091 |
| Water vapour diffusion resistance factor (μ) (4) | ≥ 80 | - | EN 12086 |
| Dimensional Stability | ≤ 5 | % | EN 1604 |
| Reaction to fire | E | Euroclase | EN 13501-01 |
| Coefficient of linear thermal expansion | 0,07 | mm/m·K | - |
| Working temperature range (Celsius degrees) | -50 / +75 | oC | - |
| Specific heat | 1.450 | J/kg·K | - |
| Nominal density | 38 | kg/m3 | EN 1602 |
| Capillarity | Null | - | - |
| Edge treatment | Shiplap | - | - |
| Surface | Skinned | - | - |
(1) Declared thermal conductivity λD according to EN 13164 (§ 4.2.1; Annex A; Annexes C.2 y C.4.1) _ EN 13164. Harmonized Technical Specification for factory made thermal insulation XPS foam products. Valid for CE marking and voluntary quality marks purposes. _
(2) Short-term (instant) test method; value reached at yield point or 10% deformation, whatever it comes first. _
(3) Creep: long-term deformation under constant loading _
(4) For skinned products it depends on thickness: the higher the thickness, the lesser the m-value
